Nice two hour lunch of sleepy chicken
Screwed in the nine 4" slats on the 20' wall nice and level with the existing white wooden wall
Cut 20' top channel which still needs 1/16" miter
Shortened the vertical slat channels on the street side by 1" to cover the end of the 2x8
Finished screwing 9 five-inch slats on the 20' wall right at noon
Читать полностью…We got the last two panels in before lunch today then went for Subway
Читать полностью…Don got the roof panels screwed into the receiver channels from the top and I from the bottom. He caulked some up top
Читать полностью…Rained a bit while eating our burgers. Got back probably around 3:00 and put a third panel on. Then around 4:30 we got greedy and tried a fourth panel and couldn't get it installed.
Читать полностью…I screwed in all the screws on the bay side of posts #2 & #4
Читать полностью…Don tacked the slat channel up post #2 by launching crooked rockets and introduced a half-inch offset that he seems ok with
Читать полностью…We got on-site this morning before 8:00 and Bob was here and things are good.
Читать полностью…Vacuumed tiles
Cut gutter corner supports
Cut roof panel to length
Resized 2nd 20-footer
Lowe's
Long 5/32 drill bit
Mini ShopVac
Ext cord
10 sheets 1/2 Plywood
Circular saw blade
Cleaner
Paint rollers
Drew the Grid on the tops of all the posts, tacked in three gutters, caulked in the gutter drops & exists and tacked in two receiver channels
Читать полностью…Cleaned up the miter cuts on the gutter facia and cut the drops out
Removed all four posts and pre-threaded the plates then reinstalled the posts