We got the last two panels in before lunch today then went for Subway
Читать полностью…Don got the roof panels screwed into the receiver channels from the top and I from the bottom. He caulked some up top
Читать полностью…Rained a bit while eating our burgers. Got back probably around 3:00 and put a third panel on. Then around 4:30 we got greedy and tried a fourth panel and couldn't get it installed.
Читать полностью…Tacked post 4
Done with Apple break
Ready to cut gutter facia again with circular saw
I screwed in all the screws on the bay side of posts #2 & #4
Читать полностью…Don tacked the slat channel up post #2 by launching crooked rockets and introduced a half-inch offset that he seems ok with
Читать полностью…We got on-site this morning before 8:00 and Bob was here and things are good.
Читать полностью…Vacuumed tiles
Cut gutter corner supports
Cut roof panel to length
Resized 2nd 20-footer
Lowe's
Long 5/32 drill bit
Mini ShopVac
Ext cord
10 sheets 1/2 Plywood
Circular saw blade
Cleaner
Paint rollers
Drew the Grid on the tops of all the posts, tacked in three gutters, caulked in the gutter drops & exists and tacked in two receiver channels
Читать полностью…Cleaned up the miter cuts on the gutter facia and cut the drops out
Removed all four posts and pre-threaded the plates then reinstalled the posts
Figured out post #2 slat channel is 126" including the 3" top channel [alligator demon was discussed nicely]
Читать полностью…