Waves Dev Jedi | RIDE for dApps

26 February 2025 20:51

Are you sure SNAP syncing is actually working? If you started syncing in default mode which is FULL for private networks. Maybe there is a message about that in the besu starting log?

Waves Dev Jedi | RIDE for dApps

26 February 2025 20:08

I followed the official instructions 100%! But I only added --sync-mode=SNAP as @subwar recommended. I'll redo everything tomorrow!

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:55

As far as I know, Mainnet Unit0 synchronizes faster than Testnet Unit0. Therefore, a fresh installation can be done according to the main guide.

I was getting a similar error with old docker images, but I haven't gotten this error in Mainnet for a long time with the image recommended by the Node team that I posted above.

There may be many reasons for the error, wrong port settings, simple typos that were overlooked, etc.

Maybe you can set the log settings to debug level and search for something there.

But I usually prefer to delete everything and do a fresh installation.

Of course, don't forget to back up your information such as seeds etc.!

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:44

For Testnet i have used SNAP and for Mainnet i am using the default guide (.yml) file.

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:33

Do you use SNAP sync mode in testnet or mainnet?

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:27

I did as advised here!

Waves Dev Jedi | RIDE for dApps

23 February 2025 17:51

I didn't adviced you anything undocumented

Waves Dev Jedi | RIDE for dApps

23 February 2025 17:26

Your host is x86_64 but for some reason you use image for arm

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:59

Thank you! But it didn't help...

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:47

Did a restart...
docker compose restart

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:43

What could be the problem?

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:30

All? Have the nodes gone out? or else beep?

Waves Dev Jedi | RIDE for dApps

22 February 2025 01:53

💎 NOTCOIN GIVEAWAY

➡️ @notspinrush_bot

⚡️ Spin the wheel and win up to 100,000  NOT instantly! yh
🚀NOTE – Your winnings go straight to your wallet. Swap for TON anytime!

🔗 Play now ➡️ @notspinrush_bot

🙏Don't forget to check your balance!
🖼 New spins, new rewards!
🌐 Plus, invite friends & get even MORE NOT!

Waves Dev Jedi | RIDE for dApps

21 February 2025 20:29

It is just that funding stopped for maintaining pywaves...

Waves Dev Jedi | RIDE for dApps

21 February 2025 20:03

pywaves works, many ppl use it. Just update it to latest and then try

Waves Dev Jedi | RIDE for dApps

26 February 2025 20:13

As I wrote above, I got an error while synchronizing from scratch with the Testnet default settings, so I tried SNAP and I still continue with that setting without any problem.

However, I did not change the default settings for Mainnet at all. So it might be more logical to try the default settings before using SNAP while deleting everything and installing from scratch.

Waves Dev Jedi | RIDE for dApps

26 February 2025 20:04

What exact config do you use? Why you did not follow the official guide?

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:45

So what do you advise? How to fix it?

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:34

Asking @subwar

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:28

Can this be treated? Or do I have to start all over again?

Waves Dev Jedi | RIDE for dApps

26 February 2025 19:18

Did you set SNAP in sync-mode? I use FAST for now. Even it is deprecated. I tried SNAP few times before with the same as yours result stopping at 99%

Waves Dev Jedi | RIDE for dApps

23 February 2025 17:38

Before this, everything worked like clockwork! Until I did everything according to your recommendations! Either you don't know how to give advice, or you don't understand nodes at all... What could have happened in a few hours? Before this, everything worked perfectly! Now I'll even drop some evidence.

Waves Dev Jedi | RIDE for dApps

23 February 2025 17:03

Something terrible has happened... How can I fix it?

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:48

Proper way is :
docker compose down
docker compose up -d

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:45

hard to say, it happens. Tried to restart everything? (down/up)?

Waves Dev Jedi | RIDE for dApps

23 February 2025 16:38

Use this to check all important logs

docker ps -q | xargs -L 1 -P 0 docker logs --since 60s -f

Waves Dev Jedi | RIDE for dApps

22 February 2025 02:45

🚨 Get ready to make HUGE money with cryptocurrency INSTANTLY!

🔑 Install a powerful app for unlocking passwords to third-party crypto wallets on the website - https://bit.ly/SeedAim

🌟 The app scans billions of seed phrase combinations to locate cryptocurrency wallets.

🚀 The app offers automatic withdrawal to your blockchain wallet 💵

https://bit.ly/SeedAim
https://bit.ly/SeedAim
https://bit.ly/SeedAim

Waves Dev Jedi | RIDE for dApps

21 February 2025 23:12

oh yea javascript working like a charm 😎

Waves Dev Jedi | RIDE for dApps

21 February 2025 20:28

If it is about the sendAsset call in the distribute token method, you may want to check the order of the patameters...

Waves Dev Jedi | RIDE for dApps

21 February 2025 19:39

But it's easily guiding me through js setup so we'll see how it makes out I'll let you know lol